![]() Remove air box and intake piping so that you can access the precontrol and WG.Solenoid will result in low boost, not max boost.) ![]() If air doesn't flow there is probably a problem. The solenoid (NO or COM port) you will feel a little resistance, but air willįlow. Wastegate actuators, thus allowing user control of boost. STEP 1) Install the Solenoid The solenoid controls the air pressure provided to the precontrol and Similar to installing this unit, and the pictures on Rob's site are very the principals of installing any EBC are very The supplied installation instructions aren't bad, followĪlso, you should review the boost controller installation info on Steve Cirian'sĪnd Rob Robinette's sites. The single most time-consuming step is splicing INSTALLATION Installing the unit will take 3-6 hours, depending on how mechanically andĮlectronically inclined you are. Please be careful, you can easily pop your motor with this thing! I assume no responsibility for anything** at least well enough to provide some help with installation and tuning. How to Install and Tune an AVC-R Boost Controller By Azeem Raja After playing with my AVC-R for a couple of weeks I think I have figured it
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |